• Provides a safe, fall arrest rated 22kN anchor point for vertical concrete applications
• Portable and reusable anchor can be removed and simply re-installed in a new location for added jobsite flexibility and lower overall cost of ownership
• Exclusive quick-release button boosts productivity by providing immediate anchor removal for added worker satisfaction
• Virtually eliminates the need for tools to remove a stuck anchor from the hole, giving the user instant mobility
• Unique forged connection ring provides a compatible tie-off point for your personal fall arrest system for added safety
• Load cable and chock release cables are shielded from damage caused by grinding against the concrete lip of the hole for a longer service life
• Exclusive pivoting easy-grip handle provides cable kink protection for added safety and longer service life
• Constructed of stainless steel, aluminum and other non-corrosive materials for a longer service life
• Designed for use in cured concrete with a compression strength of at least 21MPA
• Complies with AS/NZS 1891.4

Complete Versatility and Flexibility
For added versatility, the portable and reusable concrete anchor can be used over and over for vertical concrete applications. It incorporates an exclusive quick-release button boosting productivity by providing immediate anchor removal where other anchors bring work to a standstill. Our anchor virtually eliminates the need for tools to remove a stuck anchor from the hole – No more jobsite scavenger hunts to locate a hammer and a punch to remove a stuck anchor! The anchor was designed with strength and flexibility in mind. It is 22kN rated, and an ideal connection point for a personal fall arrest system, work positioning system, personnel riding system or rescue system. In addition, a truly “compatible” connection ring unlike any other on the market makes tying off to this device safe and secure.

Extremely Easy Installation and Removal
Installation is simple and efficient, taking just seconds utilising standard concrete tools. First, drill a 76mm deep 19mm hole at the desired mounting location with a rotary hammer and 19mm drill bit. Next, place your thumb in the anchor D-ring and pull up on the chock handle with two fingers until fully retracted. Insert the anchor into the mounting hole until the release button seats against the concrete surface. Finally, pull up on the anchor D-ring to set the anchor, and your ready to go! Release of the anchor is just as fast, simply push down on the release button and pull up on the chock handle and your ready to move to the next location.

Note: The lanyard and lines should always apply the load in shear, not in direct pull.